Thingiverse
Ratchet type Toothpaste Squeezer by wayne0
by Thingiverse
Last crawled date: 4 years, 7 months ago
Print one off of each STL (Body, Shaft, Ratchet & Clip).
Clean Parts from Support Material.
The Ratchet part pins will fit into the Body's holes. Then slide the shaft thru the Body until the Ratchet's teeth engage with the teeth on the inside face of the shaft.
The Clip will secure the shaft from falling out.
Clean Parts from Support Material.
The Ratchet part pins will fit into the Body's holes. Then slide the shaft thru the Body until the Ratchet's teeth engage with the teeth on the inside face of the shaft.
The Clip will secure the shaft from falling out.