Thingiverse
RasPiClip
by Thingiverse
Last crawled date: 4 years, 3 months ago
Simple clips to hold a RasPi 3 in it's case. I use it to hold my RasPi in place right under a board with the 3D-Printer.
The measures of the case I bought are are
width 70mm
height 25mm
I used small SPAX screws to mount it to the wooden board. The end part is kind of stiff, so the RasPi will slide on sideways. The smaller clip is flexible enough to snap it in.
All ports and the MicroSD card remain accessable.
The measures of the case I bought are are
width 70mm
height 25mm
I used small SPAX screws to mount it to the wooden board. The end part is kind of stiff, so the RasPi will slide on sideways. The smaller clip is flexible enough to snap it in.
All ports and the MicroSD card remain accessable.
Similar models
thingiverse
free
Sino:bit case by larryl719
... devices at the moment, i put tie wraps through the pairs of holes on either side by the buttons to hold the board into the case.
thingiverse
free
Enclosure Clips by BBoHK
...enclosure clips by bbohk
thingiverse
the clips i used to hold card board paper enclosure for my hypercube 3d printer.
thingiverse
free
Case for SR04T ultrasonic sensor
...s to lazy to implement a clip mechanism for closing the case.
just use a cable tie or electrical tape to hold the cover in place.
thingiverse
free
M3 Spacer 28mm with mounthole by Denny77
...our projects. in my case it holds a raspi case under a shelf board to protect overheating.
all holes for m3 screews.
height: 28mm
grabcad
free
Drawing board clip
...drawing board clip
grabcad
used for holding the drawing sheet on drawing board.
grabcad
free
Raspberry board casing
...raspberry board casing
grabcad
a board used to hold raspberry board
thingiverse
free
90 Degree angle clips for 5mm foam board by Ganderloof
...hingiverse
i designed this clip to hold squares of 5mm foam board together for a printer enclosure. might well have other uses.
thingiverse
free
Prusa MK2 Raspi Zero-W and Cam Z-axis holder by BassBoi
...fectly in the ikea lack box i made.
use support from bed only :-)
suggesting using petg or abs if it's ment to be in the box.
thingiverse
free
TwixT Game Full Size - game case by juholga
...a
thingiverse
this is a simple container box for the twixt game.
i also created a better clip to hold the board pieces together.
thingiverse
free
JR-DSMX Module Case with RP-SMA Antenna by jprikkel
...ips that hold the module in place will break if printed with pla. i printed with 25% fill to enable the part to be more flexible.