Thingiverse
Raspberry Pi Pocket with PiCam mount for Tinkerine Ditto Pro by gszczyrbak
by Thingiverse
Last crawled date: 4 years, 8 months ago
This bracket holds a CanaKit Raspberry Pi (without the lid) and attaches to the Tinkerine Ditto Pro. It has a place to mount a swivel PiCam mount as made by DanielBull.
The Pi pocket is a little tight and so is the part that hangs on the printer, but it fits. The PiCam doesn't swivel much on the Tinkerine due to my placement of the mounting hole.
The PiCam bracket is modified to accept a v2.1 PiCam. The chip pushes out a little to the right and didn't fit in Daniel's original design. It also has additional holes to mount the camera in either direction.
The camera mount back is the same as DanielBull's, but I included it here for convenience.
The PiPocket has holes in the bottom for access for the ethernet and USB connections.
The Pi pocket is a little tight and so is the part that hangs on the printer, but it fits. The PiCam doesn't swivel much on the Tinkerine due to my placement of the mounting hole.
The PiCam bracket is modified to accept a v2.1 PiCam. The chip pushes out a little to the right and didn't fit in Daniel's original design. It also has additional holes to mount the camera in either direction.
The camera mount back is the same as DanielBull's, but I included it here for convenience.
The PiPocket has holes in the bottom for access for the ethernet and USB connections.