Thingiverse
Raspberry Pi 2,3 Case by Jaypirnts
by Thingiverse
Last crawled date: 4 years, 7 months ago
My Pi is overclocked and sometimes shutdown itself because of heating problem.
So I needed a proper case under those conditions,
1) air should travel freely.
2) big fan (50mm) adopter
3) float from the ground
4) webcam adopter (optional)
As far as I know, there's no such thing satisfy everything.
I'm thinking of making fan adopter for 30mm, 40mm fan if there's a request.
No need
1)support structure
2)bolt or nuts (ovbiously for structure itself, need 4 of m3 bolt for 50mm fan)
If you planned to put gopro on it then print "Roof (for gopro mount).stl" intead of "Roof.stl" and you will need two of m3 8mm or longer. (nuts recommended but works without it)
Good luck overclock manias!
https://www.youtube.com/watch?v=-xaETeO7D-E
So I needed a proper case under those conditions,
1) air should travel freely.
2) big fan (50mm) adopter
3) float from the ground
4) webcam adopter (optional)
As far as I know, there's no such thing satisfy everything.
I'm thinking of making fan adopter for 30mm, 40mm fan if there's a request.
No need
1)support structure
2)bolt or nuts (ovbiously for structure itself, need 4 of m3 bolt for 50mm fan)
If you planned to put gopro on it then print "Roof (for gopro mount).stl" intead of "Roof.stl" and you will need two of m3 8mm or longer. (nuts recommended but works without it)
Good luck overclock manias!
https://www.youtube.com/watch?v=-xaETeO7D-E