Thingiverse
Quadcopter H Low Center of Gravity by Xakman
by Thingiverse
Last crawled date: 4 years, 5 months ago
Low center of gravity H frame quadcopter. Work in progress, Fly's good.
1: camera gimbal updated, v2 files added.
2: screw holes are a bit tight, might need drilling, I used small screws for lid.
3: Lid is a tight but fits, no vent holes.
Probably some other changes needed so I have provided the FreeCAD file if anyone wants to make any changes. Also I used blender to make the cut for the servo arm.
Flight Controller: CC3D
Motors: Multistar 2213-935
Speed Controllers: Turnigy Plush 30A
Camera: RunCam Owl2
Video Transmitter: N/A
Receiver: N/A
Props: 8"
Battery: 3300 mAh 3s 11.1v 50c (this frame will fit way bigger, I have a 5200 mAh 14.8v 4s 10c that fits)
Can be picked up from the top, no flex. Have not crashed it (yet)... ack nooo..
1: camera gimbal updated, v2 files added.
2: screw holes are a bit tight, might need drilling, I used small screws for lid.
3: Lid is a tight but fits, no vent holes.
Probably some other changes needed so I have provided the FreeCAD file if anyone wants to make any changes. Also I used blender to make the cut for the servo arm.
Flight Controller: CC3D
Motors: Multistar 2213-935
Speed Controllers: Turnigy Plush 30A
Camera: RunCam Owl2
Video Transmitter: N/A
Receiver: N/A
Props: 8"
Battery: 3300 mAh 3s 11.1v 50c (this frame will fit way bigger, I have a 5200 mAh 14.8v 4s 10c that fits)
Can be picked up from the top, no flex. Have not crashed it (yet)... ack nooo..