Pumpkin Long

...ng:60728 using rhinoceros 5 ears came out really long and very thin when i shrank the model down. printed at .3 mm with support.

...pumpkin /kürbis thingiverse pumpkin

...pumpkin by magistrareardon thingiverse a pumpkin

...pumpkin by saiga thingiverse pumpkin

...pumpkin by njary thingiverse just a pumpkin

...sp00ky pumpkin thingiverse spooky pumpkin

...pumpkin thingiverse just a plain pumpkin.

...pkin by savagewarlord thingiverse halloween pumpkin by waynerodriguez8http://www.123dapp.com/creature/halloween-pumpkin/2844277

...ing uses an led and a 2032 battery. the pumpkin is a real pumpkin that was scanned. the holes were installed using tinkercad.com.

...halloween pumpkin by bjwilliam thingiverse halloween pumpkin

...pumpkin thingiverse just a plain pumpkin.

...pumpkin thingiverse this is a typical pumpkin i made for autumn season.

...pumpkin thingiverse needed a pumpkin i could add light to, this was the best

...pumpkin /kürbis thingiverse pumpkin

...pumpkin by magistrareardon thingiverse a pumpkin

...pumpkin by saiga thingiverse pumpkin

...pumpkin by njary thingiverse just a pumpkin

...sp00ky pumpkin thingiverse spooky pumpkin

...pumpkins thingiverse pumkpkins

...long support thingiverse long support 200mm long

...spring long thingiverse spring long

...rse corner long for gopro mount there are two versions: long solid corner [corner_long] long angle lightened [corner_long_light]

...long plate by syzguru11 thingiverse long plate

...long teeth by syzguru11 thingiverse long teeth

...the long shaddow of catman thingiverse the long shaddow of catman

...long sleeve by sanj997 thingiverse long sleeve for quadcopter.

...long sword by 5555fives5 thingiverse this is a 32 inch long sword

...long tweezers by david4974 thingiverse long tweezers (about 160mm)