Thingiverse
Pubg Phone Trigger by sekshi
by Thingiverse
Last crawled date: 4 years, 1 month ago
Very Simple and small trigger for all you mobile needs.
Printed at .2 with 40% infill, takes 14 mins to print. (you can use less infill)
Things you need:
Shrink tubing
wire- any wire will do, i used solid copper wire.8mm
aluminum tape
aluminum flat bar 1/4x6"
this was the tricky part, you can use aluminum tape but i found it works best if you put a peice of aluminum flat bar on top of the copper wire then aluminum tape. Keeps the wire from poking though, also it fixes the issue with trigger from stopping. all that will go on the side that contacts the phone with shrink around it. thread the wire through the slots and at the end where your finger will contact the wire put a bit of hot glue at the end so you don't poke yourself. takes about 10 mins to build and your set. Hit me up if you have any questions
Printed at .2 with 40% infill, takes 14 mins to print. (you can use less infill)
Things you need:
Shrink tubing
wire- any wire will do, i used solid copper wire.8mm
aluminum tape
aluminum flat bar 1/4x6"
this was the tricky part, you can use aluminum tape but i found it works best if you put a peice of aluminum flat bar on top of the copper wire then aluminum tape. Keeps the wire from poking though, also it fixes the issue with trigger from stopping. all that will go on the side that contacts the phone with shrink around it. thread the wire through the slots and at the end where your finger will contact the wire put a bit of hot glue at the end so you don't poke yourself. takes about 10 mins to build and your set. Hit me up if you have any questions