Thingiverse
PS3 Controller Holder by Graystone
by Thingiverse
Last crawled date: 4 years, 3 months ago
Easy to print holder for two PS3 controllers.
Put it all together with contact glue.
Notes:
You may need to sand a little bit to fit the holders into the base.
Take care to have the wide part of the base plate to the rear.
Note that the Controller plates go in upside down. The chamfered edge should face downwards.
Put it all together with contact glue.
Notes:
You may need to sand a little bit to fit the holders into the base.
Take care to have the wide part of the base plate to the rear.
Note that the Controller plates go in upside down. The chamfered edge should face downwards.