Thingiverse
Prusa i3 Einstein Y-axis corners for 10mm smooth rods and higher-profile M10 washers and nuts by zennmaster
by Thingiverse
Last crawled date: 4 years, 7 months ago
The M10 hardware that I used for my single-sheet Prusa i3 Einstein variant protruded below the bottom of the stock Y-corner, so I raised the threaded rod holes by 2mm. The top is also modified to accommodate 10mm smooth rods.
I would recommend using the stock Y-corners unless you run into a similar problem.
I would recommend using the stock Y-corners unless you run into a similar problem.