Thingiverse
Pro trinket box (small) by jimlee
by Thingiverse
Last crawled date: 4 years, 7 months ago
A printable box to fit an Adafruit Pro Trinket processor. (Smaller than original)
The processor & charging setup are mounted to the bottom of the box by a couple 2mm socket cap screws. Bosses for these are printed in the bottom of the box.
There is still room to fit a 150mah lipo battery and more left over for some sensors & wiring.
The processor : https://www.adafruit.com/product/2000
The charger : https://www.adafruit.com/product/2124
The switch : https://www.adafruit.com/products/805
The Lipo battery : https://www.adafruit.com/product/1317
The tiny little mounting screws : https://www.boltdepot.com/Product-Details.aspx?product=6358
The processor & charging setup are mounted to the bottom of the box by a couple 2mm socket cap screws. Bosses for these are printed in the bottom of the box.
There is still room to fit a 150mah lipo battery and more left over for some sensors & wiring.
The processor : https://www.adafruit.com/product/2000
The charger : https://www.adafruit.com/product/2124
The switch : https://www.adafruit.com/products/805
The Lipo battery : https://www.adafruit.com/product/1317
The tiny little mounting screws : https://www.boltdepot.com/Product-Details.aspx?product=6358