Thingiverse
PrintRite- Ramps 1.4 housing add-on by shawdreamer
by Thingiverse
Last crawled date: 4 years, 5 months ago
add-on to my existing PritnRite-to Ramps housing design.http://www.thingiverse.com/thing:1639786
This Add-on is to address an issue some have had when inserting/removing the SD card, its been mentioned that it can be difficult to grasp the SD card due to its close proximity to the facia once inserted.
unfortunately its not possible to re-position the SD card slot to a more favourable position without serious modification to the overall design (paramount to starting from scratch tbf) so I came up with this little work-around thats both practical and fits well both physically and aesthetically with the original housing design.
hope everyone likes it as much as I am already.
This Add-on is to address an issue some have had when inserting/removing the SD card, its been mentioned that it can be difficult to grasp the SD card due to its close proximity to the facia once inserted.
unfortunately its not possible to re-position the SD card slot to a more favourable position without serious modification to the overall design (paramount to starting from scratch tbf) so I came up with this little work-around thats both practical and fits well both physically and aesthetically with the original housing design.
hope everyone likes it as much as I am already.