Thingiverse
PrintRite DIY 3d Printer Spool Holder Supports by Ballooningrich
by Thingiverse
Last crawled date: 4 years, 5 months ago
Here we have a set of three spool holder supports designed to be used with the Print-Rite DIY 3d printer when used in conjunction with the Print-Rite stand by Fab-ster (http://www.thingiverse.com/thing:1216052). It has been designed to fit stand material with a width of 18mm.
You may have to adjust the dimensions to fit your stand but I have included the STL files as well as the gcode. The two outside supports have been designed to fit the slots on the Print-Rite spool holder to stop any movement with the centre flat for support only.
Mounting
Drill a small 2mm hole on the lower rear bracket back support and secure to the stand upright with a small screw or I guess you could hot glue it.
If you have not made this stand (or something similar) give it a go as it makes a huge difference to the print quality.
You may have to adjust the dimensions to fit your stand but I have included the STL files as well as the gcode. The two outside supports have been designed to fit the slots on the Print-Rite spool holder to stop any movement with the centre flat for support only.
Mounting
Drill a small 2mm hole on the lower rear bracket back support and secure to the stand upright with a small screw or I guess you could hot glue it.
If you have not made this stand (or something similar) give it a go as it makes a huge difference to the print quality.