Printable ZX Harlequin enclosure (In Progress) by mcividino

Last crawled date: 4 years ago

This is an alternative enclosure for the ZX Harlequin.
ZX Harlequin is modern ZX Spectrum clone that can be purchased in kit form.
These are the target features:
3D Printable without support material
3 parts. Base and 2 cover pieces
Use the regular ZX Spectrul rubber keyboard, membrane and faceplate
Resemble the original case, but without branding.
Holes for ROM selection and reset switches that will go loctited in the base part.
06/18/2018 - At this point the base design is completed, printed an validated.
Front screws go under the faceplate which is a weak point.
Later will change the design so the screws can be put from the bottom, allowing disassembly without having to remove the faceplae.
Next step is to design the rear cover. It will have a ventilation grill, which I think is the proper place for it.