Thingiverse
Preliminary_CR-10S X_axis support structure by JacobMolbech
by Thingiverse
Last crawled date: 4 years, 7 months ago
Preliminary files specs and drawings
Please note:
The primary file
STL_Cr-10S_X_axis_Support_rev_6_v38_v2.stl
has been replaced with
Cr-10S_X axis Support_rev 6 v39.stl
Changes:
Holes on the far left and the far rigth (frontal view) has been updated.
Cause/impact:
The smaller holes in the file STL_Cr-10S_X_axis_Support_rev_6_v38_v2.stl
must be altered to a diameter big enough to fit the flat head screws.
PLEASE MEASURE YOUR X-AXIS ALIGNMENT BEFORE INSTALLING!
Measure from the bed to each side of the x-axis to determine if the x-axis is out of alignment.
Proper alignment can be done by adjusting the screws that are attached to the dovetail nuts, and the inner whell nut on left side(extruder side).
After installing, ensure the alignment is the same.
Important
This construction will only give rigidity to the X-axis, not aling the axis.
Will be updated asap
Please note:
The primary file
STL_Cr-10S_X_axis_Support_rev_6_v38_v2.stl
has been replaced with
Cr-10S_X axis Support_rev 6 v39.stl
Changes:
Holes on the far left and the far rigth (frontal view) has been updated.
Cause/impact:
The smaller holes in the file STL_Cr-10S_X_axis_Support_rev_6_v38_v2.stl
must be altered to a diameter big enough to fit the flat head screws.
PLEASE MEASURE YOUR X-AXIS ALIGNMENT BEFORE INSTALLING!
Measure from the bed to each side of the x-axis to determine if the x-axis is out of alignment.
Proper alignment can be done by adjusting the screws that are attached to the dovetail nuts, and the inner whell nut on left side(extruder side).
After installing, ensure the alignment is the same.
Important
This construction will only give rigidity to the X-axis, not aling the axis.
Will be updated asap