Thingiverse
PowerSpec 3D front door arm by Dbryan
by Thingiverse
Last crawled date: 4 years, 1 month ago
I needed something to keep the printer door open at times. This is a fairly simple arm and post. The arm pivots in a clevis and pin base, and hooks onto the bar post on the printer door.
Mounting tape was used to stick the pieces once aligned.
The arm is shown flipped back on top of the printer while printing ABS.
Nothing special about printing other than using some supports in the small holes.
The original upload contained the wrong stl file which has now been replaced with the actual parts used.
Mounting tape was used to stick the pieces once aligned.
The arm is shown flipped back on top of the printer while printing ABS.
Nothing special about printing other than using some supports in the small holes.
The original upload contained the wrong stl file which has now been replaced with the actual parts used.