Power Caddy, Caddy by lanepulcini

Last crawled date: 3 years, 5 months ago

Designed to give easy access to an outlet wherever needed in the garage, while still allowing me the ability to take it down with minimal effort. Caddy can also be used as wall storage if mounting over head is not what you’re looking for. Designed specifically for the “Woods Power Caddy” found below, but because the three pieces are separated from one another, it should allow for other models as well.
Slot height is 54.00mm’s
Length of the sides are 98.00mm’s
Length of the back brace is 107.00mm’s
https://www.amazon.com/Woods-2801-Power-Extension-25-Foot/dp/B000GAS3A8/ref=sr_1_2?ie=UTF8&qid=1511378203&sr=8-2&keywords=Power+Caddy
How To Print:
Choose a single back brace (Left or Right), choose the opposite side that your plug is on.
Print them standing up with support touching the build plate
I printed mine with 40% infill, minimum would probably be 30%
I mounted mine with #12 1 inch self tapping medal screws