Thingiverse
POV Spinner by KeeleyTechLab
by Thingiverse
Last crawled date: 4 years, 1 month ago
Persistence of Vision Spinner. Inspired by Tinkernut's, I decided to make my own.
I added a channel to run the wires for power through the spinner. I just paused my print the layer before they were covered up, ran the wires and then restarted. There are 3 small tabs on each side that hold the circuit board in place. If you use the same battery holder as I did it snaps right in. The side with LEDs and ATtiny however you have to use thin wire and clip all leads or solder on the back as flush as possible or it will sit too high to snap in with the tabs.
Code on my Github -> https://github.com/tkeeley/Arduino/blob/master/POV-Spinner.ino
*Thanks to Tinkernut for doing the leg work on this. I just modified his code so there was an option to put a space in the text.
https://youtu.be/Uyr0nVz_pis
I added a channel to run the wires for power through the spinner. I just paused my print the layer before they were covered up, ran the wires and then restarted. There are 3 small tabs on each side that hold the circuit board in place. If you use the same battery holder as I did it snaps right in. The side with LEDs and ATtiny however you have to use thin wire and clip all leads or solder on the back as flush as possible or it will sit too high to snap in with the tabs.
Code on my Github -> https://github.com/tkeeley/Arduino/blob/master/POV-Spinner.ino
*Thanks to Tinkernut for doing the leg work on this. I just modified his code so there was an option to put a space in the text.
https://youtu.be/Uyr0nVz_pis