Popsocket Mega Stand Version 2 by AshFlaw

Last crawled date: 5 years, 4 months ago

Following on from the Popsocket Mega Stand https://www.thingiverse.com/thing:4736924/. This is version 2.
Shared Components
Popsocket-MegaStandBase_v1.stl
The base which all the fixtures rely on
Popsocket-MegaHolder-Extension-Type1_v2.stl
Height extension fitting, print as many as you want or none at all
Textured for better grip
Option 1
Popsocket-MegaHolder-Type1_v1.stl
Simple straight screw-on holder
Lowest centre of gravity
0 degrees on the vertical plane so your phone points at the horizontal
Popsocket-MegaHolder-Type2_v1.stl
Screw-on holder which brings the phone further forward
0 degrees on the vertical plane so your phone points at the horizontal
Option 2
Popsocket-MegaHolder-Type2_v2.stl
Generic arm for holding the popsocket fixture
Popsocket-MegaHolderScrew-Type2_v2.stl
Bolt for holding the angled popsocket fixtures inplace
Popsocket-MegaHolderStand_Angled0-Type2_v3.stl
Fixture for the generic arm
0 degrees on the vertical plane so your phone points at the horizontal
Popsocket-MegaHolderStand_Angled15-Type2_v3.stl
Fixture for the generic arm
15 degrees on the vertical plane so your phone tilts up slightly
Popsocket-MegaHolderStand_Angled30-Type2_v3.stl
Fixture for the generic arm
30 degrees on the vertical plane so your phone tilts up quite a lot
Update 2021/03/24
Added images of the various configuration options.
Added stl for the cable tidy insert. (Popsocket-MegaHolder-CableHolder.stl)
Added smooth version of the extension component, it can stress a printer doing the exterior texture detail.(Popsocket-MegaHolder-Extension-Type1_Smooth.stl)