Popper lure with printing base by DIY_GUY

Last crawled date: 4 years ago

I had trouble securing the original print to the bed so I added a base for printing stability which will need trimming when finished. I also opened the hole down the center for slightly larger wire. ( 0.50 x 8" )
Please don't forget to tip if you can, Thank you in advance ;)
note*** This popper is 1.5" wide x 7.0625" long. (file name is my version not size!! )
Top and bottom print setting / concentric.
PLA with 40% honeycomb infill, 2/0 hooks and hardware these weigh 2.33 oz or 66 grams.
Added 5/8" openings for eyes to be attached.
Added grommet holes for the front,bottom and tail :)
Popper_1.5x7.3.stl has small holes for screw in eyebolts for hooks
Popper_1.5x7.4.stl has hole for swivel to loop the tru wire.
Popper 9.stl is so far the latest version with provision for grommets and small indentation to keep the through wire locked .
As always tips are greatly appreciated! :) TY!!