Pololu Zumo Reflectance Sensor Array Armor by lowlight

Last crawled date: 4 years, 2 months ago

After battling my Pololu Zumo robots for a while, one of them was blinded when it rode up the front of the other and scraped a surface mount capacitor off on the top of the plow. I decided it was time to put some basic armor on my robots so I printed an Arduino Uno plate to cover the top and designed this skid plate to protect the Reflectance Sensor Array.
There are no clips to hold it on but if your print is just right it should be a snug enough fit to hold itself on. Keep in mind that the cut of the PCB and the wiggle room of the soldered components and headers will vary a bit so you may need to tweak the SCAD file or file your print.