PlastiCopter - 3D printed 250 FPV Mini by Kuzma

Last crawled date: 3 years, 1 month ago

This was designed to be 250 mm and be able to fit a GoPro and 6 inch props!
If you don't want to spend 150$ on carbon fibre frame for quadcopter, you can print your own (ofcourse if you have a printer).
This was printed for M3 screws and holes are for Naze32.
Leave comments, let me know what you like and what has to be changed, and happy flying. :)
My electronics list:
Naze32 acro rev5 (Cleanflight 1.9.0)
SunnySky 2204 2300kv motors
DYS BL20A Mini 20A BLHeli ESC OPTO 2-4s
Gemfan 6045
Turnigy nanoTech 1000mAh 45-90C
FrSky Taranis X9D transmitter
FrSky X8R receiver
SkyZone TS5823 5.8GHz 32CH A/V 200mW Mini FPV Transmitter (v2)
Super Simple Mini OSD System for FPV
Hobbyking Multi-Rotor Power Distribution Board (DIY 8 x output PCB)
SkyZone 5.8GHz 8CH Diversity A/V Receiver w/Dual Output
Hobbywing 3A UBEC 5V 6V Switch Mode BEC For RC Models
HD Wing camera from hobbyking (don't buy it, it sucks)
Print, crash, print, crash....