Thingiverse
Pistol hanger for safe by crnook
by Thingiverse
Last crawled date: 4 years, 7 months ago
These are for hanging your pistols on the shelf in a safe. These will work for a shelf that is ~17mm thick. I have included 3 bore sizes, 45, 10mm/40cal and 9mm but you could just use 9mm for all of them.
These hangers hold a variety of firearms fine but I would not store them with a full mag in them. That might be a bit much. YMMV.
Print them on the side as shown in the preview with supports. This makes for a much stronger arm than printing it on end without supports. 50% infill works fine.
These hangers hold a variety of firearms fine but I would not store them with a full mag in them. That might be a bit much. YMMV.
Print them on the side as shown in the preview with supports. This makes for a much stronger arm than printing it on end without supports. 50% infill works fine.