Thingiverse
Piper 2 Sub 500mm Z belt drive by catspider
by Thingiverse
Last crawled date: 4 years, 10 months ago
This is a Z belt drive motor bracket for the Piper 2 sub 500mm printer. It might work for the larger one too but not tested since I don't have one.
It requires 2 608 bearings, one on top and one and one on the bottom and in my case I used my old motor coupler to hold the z lead screw from moving upwards.
Parts List:
1 gt2 60tooth 8mm bore pulley
1 gt2 20ttooth 5mm bore pulley (or matching your motor shaft)
2 608 bearings
1 motor coupler
2 washers to act as spacers between the pulley and bearing and motor coupler and bearing.
1 160mm gt2 belt.
It requires 2 608 bearings, one on top and one and one on the bottom and in my case I used my old motor coupler to hold the z lead screw from moving upwards.
Parts List:
1 gt2 60tooth 8mm bore pulley
1 gt2 20ttooth 5mm bore pulley (or matching your motor shaft)
2 608 bearings
1 motor coupler
2 washers to act as spacers between the pulley and bearing and motor coupler and bearing.
1 160mm gt2 belt.