Thingiverse
Pieta by Michelangelo (digital reconstruction) by icefox1983
by Thingiverse
Last crawled date: 4 years, 6 months ago
Copied from https://www.myminifactory.com/object/pieta-in-st-peter-s-basilica-vatican-3796.
This is a digital replica, not a scan. Original post here: http://www.zbrushcentral.com/showthread.php?195124-Pieta-Reconstruction.
Printing and removing support can be a challenge. You must print at 0.1mm layer height to show details. Support everywhere. Use support interface (Cura) is vital to removing support later. Also, use a 0.2mm support distance (default is 0.1mm) so the support isn't too stuck to the model.
The model has been uploaded earlier as https://www.thingiverse.com/thing:610630, however the model therein was somehow processed leading to a non-smooth surface. Another copy exists as https://www.thingiverse.com/thing:628663 where some supports are added. I'm uploading the clean, original version.
Also check out my uploaded Mary's bust from this digital reconstruction: https://www.thingiverse.com/thing:2651164
This is a digital replica, not a scan. Original post here: http://www.zbrushcentral.com/showthread.php?195124-Pieta-Reconstruction.
Printing and removing support can be a challenge. You must print at 0.1mm layer height to show details. Support everywhere. Use support interface (Cura) is vital to removing support later. Also, use a 0.2mm support distance (default is 0.1mm) so the support isn't too stuck to the model.
The model has been uploaded earlier as https://www.thingiverse.com/thing:610630, however the model therein was somehow processed leading to a non-smooth surface. Another copy exists as https://www.thingiverse.com/thing:628663 where some supports are added. I'm uploading the clean, original version.
Also check out my uploaded Mary's bust from this digital reconstruction: https://www.thingiverse.com/thing:2651164