Thingiverse
PiBow Support Ender 3(V2) by Swift3004
by Thingiverse
Last crawled date: 4 years, 8 months ago
Wanted to attach my Raspberry Pi to my Ender 3 V2 because of Octoprint, But couldn't find a nice solution to mound it sideways with my PiBow case.
Unitl I found this model:https://www.thingiverse.com/thing:2552992
I liked the idea of this mount and changed it so it would fit on the rails of my Ender 3 V2.
This is my first model ever edited/created, so every feedback is welcome. I put 2 versions online which differ in sd card slot orientation, so you can put your Pi on as you wish.
Credits for the design of the mount go to, I only used this design to make my version of it:https://www.thingiverse.com/darkou
I printed as follows, but be free to experiment as you wish of course. I just liked the smaller resolution and enabled support just to be sure. Infill is my default 20% and used PETG because it is a bit stronger than PLA.
Unitl I found this model:https://www.thingiverse.com/thing:2552992
I liked the idea of this mount and changed it so it would fit on the rails of my Ender 3 V2.
This is my first model ever edited/created, so every feedback is welcome. I put 2 versions online which differ in sd card slot orientation, so you can put your Pi on as you wish.
Credits for the design of the mount go to, I only used this design to make my version of it:https://www.thingiverse.com/darkou
I printed as follows, but be free to experiment as you wish of course. I just liked the smaller resolution and enabled support just to be sure. Infill is my default 20% and used PETG because it is a bit stronger than PLA.