PI 4 ice tower cooler case with 2 x 40mm fans by dewthehue

Last crawled date: 2 years, 10 months ago

use supports(tree) 100% infill, .2mm layer height, the 25mm snap youll want to do smaller, I used .12mm layer height. print it with the face down and it pushes through the back into the 25mm fan holes holding it in place.
If you purchase as many 5v fans as I did, you will need a 5 to 1 splitter, which are available on amazon: https://www.amazon.com/Splitter-Extension-Computer-Internal-Motherboard/dp/B091F1TLG1/ref=sr_1_12_sspa?dchild=1&keywords=fan+splitter&qid=1622843201&sr=8-12-spons&psc=1&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEzQVJVUlNNNUMwVlc5JmVuY3J5cHRlZElkPUEwMTIyMTQ2MklIMEdGTVNHWDZHTyZlbmNyeXB0ZWRBZElkPUEwODI4MjExMVdSNzUxSlJFTlZVSyZ3aWRnZXROYW1lPXNwX210ZiZhY3Rpb249Y2xpY2tSZWRpcmVjdCZkb05vdExvZ0NsaWNrPXRydWU=
I used these and ripped the soldered cables off, just used the ports on top.
This case includes an RFM jack for a radio antenna, which I have installed in mine, otherwise I plugged it with a rubber grommet/power button/whatever you may need it for.
USE A 7MM thick FAN on the back for the 25mm, thicker may interfere with the low profile cooler.
you must slide the fans in through the bottom, make sure to install the fans AFTER the pi4, the case can flex some and it may be difficult to get in place, you may need to push inside the back near the 3.5mm headphone port to get it in place.