Thingiverse
Pharaoh-Dog Anet A8 Circuit board case and power supply holder by MakeCents
by Thingiverse
Last crawled date: 4 years, 6 months ago
I made this to get all my electronics off of my printer, and then build a box around it. I also made a 120 mm fan mount with a frame for a screen that slides into the base. I found a way to use a power adapter to power the fan, on youtube, and i connect my printer and the power adapter to a surge protector/power strip to turn on and off my printer.
The board mounts inside.
The power supply can mount on the back, using the stock step-offs from the board.
The printer connection and the sd card fit through the side into the board.
The front just slots in the bottom and then clips in the top.
Misc hardware needed.
This could be used as just a mount for the circuit board and not the base or the power supply mounted to the back if you wanted to mound the main to a wall or something.
I put two mounts for optional mosfets near the top.
Wires will need extended, stock ones will NOT work.
Pictures included are before much cleanup, just fitting.
The board mounts inside.
The power supply can mount on the back, using the stock step-offs from the board.
The printer connection and the sd card fit through the side into the board.
The front just slots in the bottom and then clips in the top.
Misc hardware needed.
This could be used as just a mount for the circuit board and not the base or the power supply mounted to the back if you wanted to mound the main to a wall or something.
I put two mounts for optional mosfets near the top.
Wires will need extended, stock ones will NOT work.
Pictures included are before much cleanup, just fitting.