Pergo Samsung Tab S 10.5 Support by Pergo

Last crawled date: 3 years, 1 month ago

Bought the wife a Samsung Tab S 10.5 and wow this thing is awesome, but it's a monster to hold for any length of time. I seen her fidgeting with it and told her I could make her lifer easier.... and I did! had her hold it at the angle she desired took some measurements.. printed.
The mount uses a 1/2" schedule 40 PVC pipe and you can cut it to your desired length.
I designed it to print in two pieces to be glued with super glue and held with M3 8 mm long screws. Later I designed the plug that goes into the bottom of the pvc pipe. print the plug right side up like a mushroom grows with supports. Break away the supports and it should pop into the pipe with a nice easy fit.
If you desire a different angle, give me the mm measurement from the pipe to the back of the support. In the stock model this measurement was 70 mm (this will help you understand where I measured.