Thingiverse
Peopoly Moai Heater Installation by fcollingwood
by Thingiverse
Last crawled date: 4 years, 3 months ago
I recently installed a CSF060 din rail mounted heater and a W1411 thermostat to my Moai to solve some printing issues. As I would need to supply 220V to the printer, I mounted the PSU inside the case.
NOTE: As there is now mains voltage wiring inside the printer, the metalwork MUST be earthed. I drilled a hole in the base plate, crimped in a nutsert and fastened earth off the IEC socket to this point.
Here are the parts I printed to aid the installation, and some photos of how they are used.
NOTE: As there is now mains voltage wiring inside the printer, the metalwork MUST be earthed. I drilled a hole in the base plate, crimped in a nutsert and fastened earth off the IEC socket to this point.
Here are the parts I printed to aid the installation, and some photos of how they are used.