Thingiverse
Peon 230 landing gear
by Thingiverse
Last crawled date: 5 years, 3 months ago
This is a snap-on landing gear that fits into the rectangular holes on the Peon 230's arms. It takes some force to push it in and will stay in even on hard landings. It works best though if coming in for a landing straight down. If the drone is moving forward on the landing, the front two legs can collapse in.
I am currently working on a v2 which will clip in, so it will not come off in a crash.
There is 50mm of clearance underneath the quad, enough to put a small flashlight or to just lift it off of the ground for takeoffs and landings.
.2mm layer height
20% infill
no supports (print it laying flat)
print 4 (one for each arm)
I am currently working on a v2 which will clip in, so it will not come off in a crash.
There is 50mm of clearance underneath the quad, enough to put a small flashlight or to just lift it off of the ground for takeoffs and landings.
.2mm layer height
20% infill
no supports (print it laying flat)
print 4 (one for each arm)