Peg by SwifferKing

... mm with 8.2 mm screwhole by blazegfx thingiverse simple spacer for beiter v-box beiter spacer 30.5 x 3 mm with 8.2 mm screwhole

...x-wing peg for 1/4" sphere magnet by maverikou thingiverse x-wing peg with a magnet holder.

...lunatik taktik extreme iphone x mute peg by diepzeevogel thingiverse mute peg for iphone x case by lunatik (taktik extreme)

...tent peg (zelthering) by olima thingiverse full printable tent peg with x-profile 160mm

...se small cap to repair broken pegs on small base x-wing ships. works best if you still have the original peg, but it is cracked.

...cement by runecaster thingiverse this is a peg replacement for small ships with the 90-degree "l-shaped" receiver peg.

...ch to an ikea skadis peg board. print base, 2 x 4mm pegs, 2 x 7mm pegs. glue pegs into base. attach to your ikea skadis pegboard.

...le peg works fine for me and is easier to print. i have uploaded 2-peg versions in-case you have issues with the holder rotating.

... a genius two pegs = you're pretty smart three pegs = you're just average four pegs or more = just plain dumb good luck!!

... the 90-degree "l-shaped" receiver peg. this version has an included pin that should match close to what is being used.

...fidget spinner!! by swifferking thingiverse another fidget spinner.

...kidde smoke detector mount by swifferking thingiverse replacement mount for kidde smoke detector.

... cover set i made for a floor bolt. it makes it easier for people to use and prevents the sharp edges from tearing up your shoes.

...nt part for the shower mentioned above. it was commissioned by a friend who broke the part installing the shower. printed in petg

.... i would have made it public dedication but i am keeping with the creators wishes. i dropped the penny in while it was printing.

...th of solid wire, wrapped the battery side in a single spiral and wrapped a length of wire around the "post" 1-2 times.

...ehicle please let me know in the comments. i made the grommets larger on top so they would not pop off even if your mat was worn.

...ine threaded coolant hose. printed in petg with 10% infill. keep it slow to close and print the small end. printed mine nut down.

...is for someone else. i'll pop back if the charging port lines up. (my guess is i should have put it 30 mm towards the handle)

...peg thingiverse just a peg

...the peg game thingiverse the peg game

...shelf peg thingiverse peg for 5 mm

...tuning peg thingiverse tuning peg guitar

...pegs by adodero thingiverse peg for broken part

...he mini pegboard or a normal full size one. now you can print up holders that can be screwed to a wall or attached to a pegboard.

...peg for pegboard by joorgawt thingiverse basic pegs for peg boards

...giverse didn't find a peg that worked for my peg board. the inner diameter is 6.3mm (0.25in) and the outer diameter is 10mm.

...1" metal peg board peg set by ak999 thingiverse 1" metal peg board peg set