Thingiverse
PCB Prototype Enclosure
by Thingiverse
Last crawled date: 6 years ago
Vented enclosure for 3cm x 7cm PCB prototype board. I'm using boards from (this kit.
Just slide the board into the grooves, stick any wires into the slot, and screw the cover on with #6 screws. Wood screws were near my desk while I was designing this, but I'm sure machine screws would be fine too.
The countersunk holes on the cover need some support while printing
Just slide the board into the grooves, stick any wires into the slot, and screw the cover on with #6 screws. Wood screws were near my desk while I was designing this, but I'm sure machine screws would be fine too.
The countersunk holes on the cover need some support while printing