3DWarehouse

Parvum R1.0 mATX
by 3DWarehouse
Last crawled date: 2 years, 1 month ago
Based on actual measurements of the R1.0 mATX panels. Changes are as follows: Longer cut-out in the midplate which allows flexible tubes coming out of the passthroughs to get under to the radiators without needing any 90 degree fittings; Shorter notches for the GPU bracket - 2mm instead of the whole 5mm width. The PCIe 2.2 spec shows the cutout should start at 7.24mm so 2.75mm should be sufficient, however from experience the cutouts are often neither deep enough nor wide enough; Cut out in front panel mid to allow optional lighting of the up-down arrow; Extra two modding cubes underneath for support to stop the bottom panel from bowing so terribly under the weight of two 360mm radiators.