Thingiverse
Parkzone Habu 2 Replacement Fixed Landing Gear Block by RCexplainedOnYT
by Thingiverse
Last crawled date: 5 years, 2 months ago
This is a Printable replacement part for the Parkzone Habu 2. It is a Replacement Fixed Landing Gear Block. The stock one may break over time or even after one rough landing. This part will install in to the factory location and strong solution for the stock fixed landing gear.
To make the part even stronger, drill out enough room to place a brass tube where the landing gear extends deep inside the block. This is the area that will slowly wear due to the landing forces involved.
Here is a look at the design of the 3D Printed Landing Gear Block, placing it in the slicing software, installation and the flight.https://youtu.be/LXS-gaogiFg
To make the part even stronger, drill out enough room to place a brass tube where the landing gear extends deep inside the block. This is the area that will slowly wear due to the landing forces involved.
Here is a look at the design of the 3D Printed Landing Gear Block, placing it in the slicing software, installation and the flight.https://youtu.be/LXS-gaogiFg