Thingiverse
Parameterized vape case by oranges142
by Thingiverse
Last crawled date: 4 years, 8 months ago
STL is a vape case sized for Smok Stick X8. I haven't printed it to test the fit, but on the slicer it seems pretty close to the other one I printed that did fit.
I would use supports with this.
The cutout in the top section is to allow the user to see how much fluid remains in the tank.
You can change the diameter of the vape, the twist of each section measured in degrees. The number of slices (makes it look smoother instead of low poly).
Taper determines how much thinner the middle section is than the top and bottom.
The large cutouts are for your vape button/charging. You can edit the radius to make those cutouts larger or smaller. The offset moves the oblongs used for that in or out of case.
I would use supports with this.
The cutout in the top section is to allow the user to see how much fluid remains in the tank.
You can change the diameter of the vape, the twist of each section measured in degrees. The number of slices (makes it look smoother instead of low poly).
Taper determines how much thinner the middle section is than the top and bottom.
The large cutouts are for your vape button/charging. You can edit the radius to make those cutouts larger or smaller. The offset moves the oblongs used for that in or out of case.