Thingiverse
Oxygen/Hydrogen Separator Generator
by Thingiverse
Last crawled date: 5 years, 10 months ago
This is my version of an oxygen, hydrogen generator, with built in separator wall.
After printing you will need 2 electrodes plates (I use stainless steel for both anode and cathode).
Dimension of the plates (11cm x 9.5 cm x 1.5mm).
I suggest to glue a cloth membrane on the middle separator wall, for better (and safer) separation.
For the tubing I use flexible silicone tube 1cm diameter.
Print with at least 3 walls perimeter, 3 layers on top and bottom.
Seal everything with epoxy or hotglue.
If this thing was usefull to you consider to support me:
paypal.me/ndrcst
After printing you will need 2 electrodes plates (I use stainless steel for both anode and cathode).
Dimension of the plates (11cm x 9.5 cm x 1.5mm).
I suggest to glue a cloth membrane on the middle separator wall, for better (and safer) separation.
For the tubing I use flexible silicone tube 1cm diameter.
Print with at least 3 walls perimeter, 3 layers on top and bottom.
Seal everything with epoxy or hotglue.
If this thing was usefull to you consider to support me:
paypal.me/ndrcst