Overlord Pro - MKS Sbase mount parts by bummster

Last crawled date: 4 years, 8 months ago

Printed parts to get an MKS Sbase installed in place of the dfrobot ATMEGA based board.
Also added a bracket to hold 4x 8 diode TL Smoothers from Triangle Labs. This bracket will not work if you are using the stock microcontroller. They try to occupy the same space a little bit. It should go without saying that if you still have the backup battery in place, it won't fit either...
When I get around to it, I'll post more about how to wire it all up, config.txt settings, etc. So far everything is working just peachy though.
https://www.youtube.com/watch?v=vjXNYrzMMlU
https://www.youtube.com/watch?v=lcIQsXaitDE
WIP Parts list:
The power plug is a Kycon KPJX-PM-4S. http://www.mouser.com/Search/ProductDetail.aspx?R=KPJX-PM-4Svirtualkey51700000virtualkey806-KPJX-PM-4S
The switch is a 15mm x 10mm SPST snap in/panel fit.https://www.amazon.com/gp/product/B00X42JPP2/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
to secure the Kycon jack. You will need to redrill the Kycon jack holes to 3mm.
2x 3mm x 12mm bolt
2x 3mm washer
2x 3mm nylock
to secure MKS Sbase to tabs
2x 3mm x 8mm bolt
2x 3mm washer