Thingiverse
Orignal iPad Wall Mount by albertk836
by Thingiverse
Last crawled date: 4 years, 6 months ago
I use the original iPad for Shortwave listening and wanted to get it off the table top. The two size brackets are due to mainly forgetting about the volume control which I don't use in my application. (designed the lower bracket first) The larger bracket is the lower one to support the weight, ; ) (sounds like a good cover) The smaller bracket is the top and has a slide for the mounting screw. Tighten the top mounting screw where the top bracket will move with force to hold the iPad in place. I flanged the mounting screw holes to use #10 flat head screws however, #8 dome head screws should work fine also.
The rear mounting is .125" thick allowing the power/charger cord to be routed between the brackets if needed. (see picture)
I have placed 4) 3/8" recesses on each bracket for self adhesive felt pads to hold the iPad better.
I printed the brackets with PLA using .2 mm Layer Height and at 10% Fill.
NOTE: You could also just print two of the upper brackets for the mount, they are heavy duty enough and save some material.
The rear mounting is .125" thick allowing the power/charger cord to be routed between the brackets if needed. (see picture)
I have placed 4) 3/8" recesses on each bracket for self adhesive felt pads to hold the iPad better.
I printed the brackets with PLA using .2 mm Layer Height and at 10% Fill.
NOTE: You could also just print two of the upper brackets for the mount, they are heavy duty enough and save some material.