Thingiverse
OpenLock Adapters Plain by Start2
by Thingiverse
Last crawled date: 4 years, 5 months ago
OpenLock/OpenForge 2.0
As I have been piecing together some scenery, found I was unable to lock a couple of things together. The slots would not stagger, or mezzanines/passages conflicted around corners. Created these adapters to "switch" connection spacings. Advantage of the 1" wide adapters is that was where the changes would occur, (those little double wall corners, that 2 edge tiles would work, but not as well) a single adapter would help the layout. With 2 of the same type adapters, I also could quickly mirror the two to change the connection spacing.
The corner adapter came about, because I needed a 1' wide catwalk/mezzanine and wanted to match the typical A wall on the outside. (thus the "notches" on the bottom to fit the corbel/braces in the corner for the murder holes tiles) The corner adapter also works with the Spiral Corner Stair to help match up to the standard E tile dungeon layout, or as an open floor penetration. Also the corner adapter is good to integrate into the dungeon E style layout the 1x1 dungeon fixtures trapdoors, traps, columns etc.
Kudos to Printablesceneryhttp://www.printablescenery.com/product-category/rampage-system/
Rampage http://www.thingiverse.com/thing:1821631
OpenLock 4.0 http://www.thingiverse.com/thing:1833963
As I have been piecing together some scenery, found I was unable to lock a couple of things together. The slots would not stagger, or mezzanines/passages conflicted around corners. Created these adapters to "switch" connection spacings. Advantage of the 1" wide adapters is that was where the changes would occur, (those little double wall corners, that 2 edge tiles would work, but not as well) a single adapter would help the layout. With 2 of the same type adapters, I also could quickly mirror the two to change the connection spacing.
The corner adapter came about, because I needed a 1' wide catwalk/mezzanine and wanted to match the typical A wall on the outside. (thus the "notches" on the bottom to fit the corbel/braces in the corner for the murder holes tiles) The corner adapter also works with the Spiral Corner Stair to help match up to the standard E tile dungeon layout, or as an open floor penetration. Also the corner adapter is good to integrate into the dungeon E style layout the 1x1 dungeon fixtures trapdoors, traps, columns etc.
Kudos to Printablesceneryhttp://www.printablescenery.com/product-category/rampage-system/
Rampage http://www.thingiverse.com/thing:1821631
OpenLock 4.0 http://www.thingiverse.com/thing:1833963