Onewheel Stand with charger slot by joshtreepark

Last crawled date: 3 years, 5 months ago

I wanted to make a remix with the charger to be safely located and leave some room for cable to be crunched in when not charging.
You can print the original Onewheel stand and add this charger bracket later if you want. Print the whole thing sideways and it should print without any support.
The screw sizes are M3 countersink screws at 12mm in length. After printing the bracket, line it up and use drill bits to drill a hole through the bracket's existing holes. Insert the screws and tighten one, then proceed to drill the rest of the holes.