Olympia Drip Tray Cremina Express Coffex Maximatic Livietta by ravenloft08

Last crawled date: 3 years, 1 month ago

This is my first Maker project. I had help with this from folks at my university. It printed up great for me. I hope that this helps others!
This is a replacement drip tray for an Olympia espresso machine (Cremina, Coffex, or Maximatic) or a Pasquini Livietta (which is the rebranded Olympia).
I found it necessary to trim a few millimeters off of the top "wings" where they meet the espresso machine body (so, the "back" when looking at the machine from the front). You might need to trim it down a tiny bit and you might want to sand it a bit to get it to fit, but, the trimming was truly minimal (took me about 5 minutes to do it).
From the photos, the grey drip tray is the one that I printed (the black one is the original that I measured for correct proportions). The first three photos show 1) how the final printed tray looked from the top, 2) the grey (printed) and black (original) from the bottom, 3) the grey (printed) and black (original) from the top. The fourth photo shows the grey (printed) drip tray fitted into my Pasquini Livietta. The fifth and sixth photos show where I needed to cut off a few millimeters of plastic from the end wings so it would fit into the metal frame. The seventh photo shows how the original metal grate fits perfectly into the grey (printed) drip tray.