Thingiverse
Obi-Wan Kenobi's Lightsaber A New Hope (Episode iv) Inspired by PilksUK
by Thingiverse
Last crawled date: 4 years, 6 months ago
This is a remix of Brads Obi-Wan Kenobi's Episode 3 Lightsaber I love how easy his sabers are to print, I have simply looked at other peoples Obi Wan Ep4 Sabers and used Tinkercad to modify Brads Orignal models so all the parts will connect the same.
I also tried to keep this the same amount of parts to print its gone from 11 parts to 13 as I added my separated emitter face to this and the other extra part is the D-Ring so print time should be the same as before.
**Warning! If you use supports on the Radiator neck please check the overhang as it will be a lot of work to remove them from the finns my Cura only added supports to the socket area and not the finns so I had no clean up.
Supports should not be needed for any part personally I used supports touching buildplate for most parts that have a connection socket.
Im not 100% happy with the clamp might add more detail to it at a later date.
I also tried to keep this the same amount of parts to print its gone from 11 parts to 13 as I added my separated emitter face to this and the other extra part is the D-Ring so print time should be the same as before.
**Warning! If you use supports on the Radiator neck please check the overhang as it will be a lot of work to remove them from the finns my Cura only added supports to the socket area and not the finns so I had no clean up.
Supports should not be needed for any part personally I used supports touching buildplate for most parts that have a connection socket.
Im not 100% happy with the clamp might add more detail to it at a later date.