Thingiverse
Nyrius Receiver Upright Stand by NAnglo
by Thingiverse
Last crawled date: 4 years, 5 months ago
An upright stand I made for the Nyrius BR50 AptX Bluetooth receiver. It most likely works on the BR40 (the one without the AptX) and the BR51 (the one with the AptX and the NFC; no idea how it'll affect the NFC though). It might work with the BR41 and other bluetooth receivers of similar make as the BR50.
To make the feet, I simply cut discs from a 7mm black hot gluestick with an exacto knife - the holes at the bottom are 2mm deep, so you only need four little feet about 3mm each. Afterwards the Nyrius receiver should just slide in, and you're good to go.
I've also included a "No Feet" version, in case you don't want to bother doing the gluestick thing, or you want to resize the object to fit something larger or smaller (a Wi-Fi router, perhaps? A book?). For reference, the width of the "slot" is 2.0cm on the .stl, and fits a 1.95cm thick object (eg. the receiver) snugly.
To make the feet, I simply cut discs from a 7mm black hot gluestick with an exacto knife - the holes at the bottom are 2mm deep, so you only need four little feet about 3mm each. Afterwards the Nyrius receiver should just slide in, and you're good to go.
I've also included a "No Feet" version, in case you don't want to bother doing the gluestick thing, or you want to resize the object to fit something larger or smaller (a Wi-Fi router, perhaps? A book?). For reference, the width of the "slot" is 2.0cm on the .stl, and fits a 1.95cm thick object (eg. the receiver) snugly.