Thingiverse
NVG mounting bridge for J-arm mount by The_Gun_Foogle
by Thingiverse
Last crawled date: 4 years, 5 months ago
This is a dual mount bridge with adjustable pupilary distance, that can be mounted with the hardware from a J-arm.
Remove the two screws from the bottom of the J-arm, push the spring down, and slide the arm out of its mount. The tilt sensor and wires should not be glued in, but sometimes are.
Then place the bridge in the mount and replace the screws. I am unsure the maximum load on this bridge but the sionyx aurora camcorder is probably obese enough to snap it.
Remove the two screws from the bottom of the J-arm, push the spring down, and slide the arm out of its mount. The tilt sensor and wires should not be glued in, but sometimes are.
Then place the bridge in the mount and replace the screws. I am unsure the maximum load on this bridge but the sionyx aurora camcorder is probably obese enough to snap it.