Thingiverse
NodeMcu and 5v Single Channel Relay Enclosure by Ceasar1010
by Thingiverse
Last crawled date: 4 years, 5 months ago
ESP8266 Module ESP-12E NodeMcu LUA WiFi and a single channel 5V relay switch. Just needed something to hold the parts together conformable because I built this into a internet remote control for my garage door opener. Worked well and the lid snaps on and is very tight. I had a hard time taking it back apart.
UPDATE: I created a second version of the lid without the pegs. They work but some printers might not be able to get the detail right. On the second version there is a extending tab that will get close to the NodeMCU and keep it from flopping around. I did not add one on the relay side because I planned on a tab of hot glue on the bottom.
Also you may note that the relay is a but off center. I wanted the relay to be pinched to the side for stability. That was my design choice.
I hope you enjoy this very specific project box.
Thinking about making some wings so you can screw down this project box. Let me know if there is any interest.
UPDATE: I created a second version of the lid without the pegs. They work but some printers might not be able to get the detail right. On the second version there is a extending tab that will get close to the NodeMCU and keep it from flopping around. I did not add one on the relay side because I planned on a tab of hot glue on the bottom.
Also you may note that the relay is a but off center. I wanted the relay to be pinched to the side for stability. That was my design choice.
I hope you enjoy this very specific project box.
Thinking about making some wings so you can screw down this project box. Let me know if there is any interest.