New Raspberry Pi 4 Honeycomb case by JayCee09

Last crawled date: 4 years, 11 months ago

New Raspberry Pi 4 Honeycomb Case
Designed for Octoprint

If you are looking for a nice Octoprint case, this is right for you.
Also, Raspicam is supported!
No hustle in assembly, just three steps and you are good to go:

Print it;
Insert the Raspberry Pi;
Snap fit all together.

Simple as eating a sandwich.

No fan needed

The case is designed to optimize the air flow and to keep the Raspberry Pi well cooled without the need of a cooling fan.

How it's been made
This is a remix of my Raspberry Pi 4 case. In order to make it much easier to assemble the case with the RPi4, a few changes were made:
Divided the lower part in two halves for easier inserting of
Raspberry Pi;
Added snap fit link between upper case and lower case;
Added ribaditures to the lower case in order to keep the RPi4
board in place (using 4 M2.5x8 screws is considered but not
strictly necessary).
Minor improvements from the aesthetic point of view.
Variants
As the previous version, the upper case is provided in two variants:
Upper case cut so as to allow the passage of the RaspiCam's ribbon cable;
Upper case without the cut.
Hope you enjoy printing my designs as much as I do; if so, like or post a make and, as always, happy printing!