Thingiverse
Netgear Nighthawk Switch Wall Mount GS810EMX by mintonette
by Thingiverse
Last crawled date: 4 years, 6 months ago
Wall mount for the 10-port multigigabit Nighthawk gaming switch - because Netgear were too preoccupied adding LEDs and as many angles and as possible to this thing, they forgot to add a couple wall mount holes in the bottom, like every other switch...
The switch is fully supported and can easily be removed; it simply slots in and out via the top. The tabs either side at the top keep it firmly in place and prevent it from falling forwards if accidentally knocked. There is complete access to all ports, power connector and LED button.
This heavy boi also gets quite warm, so don't skimp on the perimeters and infill. I've printed with 4 perimeters in PLA+ but have no idea whether this will last long term. I would recommend printing in something that can withstand the constant heat.
2 versions available - full model and 2-part models for smaller print beds. Screw holes are 3.5mm. No supports needed!
The switch is fully supported and can easily be removed; it simply slots in and out via the top. The tabs either side at the top keep it firmly in place and prevent it from falling forwards if accidentally knocked. There is complete access to all ports, power connector and LED button.
This heavy boi also gets quite warm, so don't skimp on the perimeters and infill. I've printed with 4 perimeters in PLA+ but have no idea whether this will last long term. I would recommend printing in something that can withstand the constant heat.
2 versions available - full model and 2-part models for smaller print beds. Screw holes are 3.5mm. No supports needed!