NESPi 4 Game Genie w/SATA to USB Adapter by ericbsmith42

Last crawled date: 3 years ago

A simple housing for a USB to SATA adapter in the form of a Game Genie. Print the main body in Gold and the handle in Black filament. I used Superglue to stick them together. The label should be the right size if printed at 600dpi (approximately 2.8x1 inch). The plugs are designed to fill the end where the USB cable goes through. Depending on the material you use and the layer thickness they may just fit or they may be a little too big. If they are too big you can trim one or both of them down a little (In my original tests they fit perfectly, but when I switched to 0.6mm nozzle with thicker layers they were a little too big to fit in the hole with the USB cable so I trimmed them. They're small enough to reprint without worry though).
This is designed to fit an Inateck UA1002 USB to SATA adapter. It may fit other similar adapters, but you may need to remix it to get a fit since this is designed to fit the Inateck pretty snugly. You can currently find the UA1002 on Newegg or eBay:
https://www.newegg.com/p/35G-009B-00005?Description=inateck%20ua1002&cm_re=inateck_ua1002-_-9SIAMD6D8F7959-_-Product&quicklink=true
https://www.ebay.com/itm/Inateck-USB-3-0-To-SATAIII-2-5-Laptop-Hard-Disk-Drive-SSD-Adapter-Converter-New/274399676074?hash=item3fe37ec6aa:g:tCIAAOSwPCVYBun3