Nerf Longstrike Direct Plunger Conversion Parts by Stryker5260

Last crawled date: 3 years, 5 months ago

Updated! See changelog for details
These parts are used to convert an original/old (blue, whiteout and "sonic" clear green) Nerf Longstrike to a direct plunger system using parts from a Nerf Retaliator. You will need the plunger tube assembly, spring, catch plate and part of the bolt/breech from the Retaliator to complete this mod. These parts are intended to replace the "DIY" components that are shown in these guides:
http://southernbrisbanenerfclub.blogspot.com/2014/02/elite-longstrike-mod.html?showComment=1393030041807&m=1
https://imgur.com/a/V9vVy
These guides are not by me, and credit goes to those who created them. Video guide by me here:
(A bit out of date now with the updated parts, new and better vid to come)https://youtu.be/HshnAi61H7Y
Print at 100% infill and in PETG if possible for best strength, your print tolerances may vary due to machine calibration/tolerances. Print 2 of "PlungerTubeSpacer", 2 of "CatchSpacer", one of "BoltJoiner" and one of either "SpringRestLowPrecomp" or "SpringRestHiPrecomp" depending on the performance you want and spring you're using. I couldn't get the blaster to prime properly with the High Precompression rest and a 7kg spring but YMMV. All parts should already be oriented correctly when loaded and the spring rests need support from build plate only.
If you'd like a set printed, or the whole mod done by me, contact me at BlackDragonBlasterForge@gmail.com and we can work something out.
CHANGELOG:
12/11/2020 - Initial release
12/27/2020 - Made PTSpacer a single piece unit for better support of plunger tube pins, remade spring rest and added a low (close to Nerf original) pre-compression version and renamed original to "HiPrecomp". Catch spacers are now symmetrical 5mm blocks, changed from 4.5mm x 4.75mm.