Neopixel Light Bar for 2020 extrusion

Last crawled date: 4 years, 4 months ago

This is a 2020 Extrusion Neopixel light bar you can use with a 3D Printer.
This light bar goes with the YouTube video at https://www.youtube.com/watch?v=SoAcZDXzd00 where we install Neopixels into the SKR V1.4.
We first wire the Neopixels and then cover installation and configuring Marlin. We show how Neopixel LEDs trigger and display when heating. I also go into the Marlin M150 command and how you can modify your startup or other gcode to change the Neopixels to any color. This is a very simple project for any BigTreeTech SKR v1.4 owner.
Light bar 3D Printhttps://www.thingiverse.com/thing:4149850
Neopixel Reelhttps://amzn.to/31zV2zm
Resistors Assortment (which includes the 330 ohm resistor)https://amzn.to/2S89XOo
Capacitor Assortment (which has the 1000uF capacitor)https://amzn.to/3biOiKI
Heat Shrink Tubing Assortmenthttps://amzn.to/3bh1Oyu
Ribbon Cablehttps://amzn.to/3bkNIft
Crimping Toolhttps://amzn.to/2vRU3ia
Mainboard Connectorshttps://amzn.to/2UAK7Em